After successful inclusion the Z-Wave LED will When in inclusion mode, the Z-Wave LED will double blink. The button on the device 3 times in less than 2 seconds will put it back in inclusion mode for 30 seconds. After 30 seconds, if the Bridge is not included, pressing The Bridge will enter inclusion mode when first powered on (if not already included in a Z-Wave network)Īnd will stay in inclusion mode for 30 seconds. ![]() Network, the Bridge will appear as two devices: Valve’ and ‘close valve’ messages to the bridge to relay to the valve controller. It willĪlso inform the hub when an ‘all sensors dry’ message is received. When the Bridge receives a ‘leak detected’ message it will inform the Z-Wave hub if it is paired. Please see the RelayLink™ Specification Document RelayLink™ is an revolutionary, innovative new communication protocol developed by Elexa Consumer Products to be faster and easier to use than current standards. ![]() Or RelayLink™, an open or close command will be sent to the valve controller via GuardianRF. Once all of the sensors are dry, the valve controller will send a message to theīridge that all sensors are dry When the Bridge receives a command to open or close the valve from Z-Wave When any leak sensor is triggered the valve controller will send a message over GuardianRF to the bridge In case an OTW firmware update is requiredĭuring development and testing the device will be designed in such a way that the firmware can be updated GuardianRF, the Z-Wave module will be updated over Z-Wave. The Bridge will be capable of OTA firmware updates. The settings and information displayed to the user are TBD There can be only oneīridge connected to each valve controller. The Bridge can be connected to the Guardian App if the user has a valve controller. The Guardian velcro strap can be omitted. If sourcingĪ gray power supply will cause delays or too much added expense, a black power supply can be used and It will be gray and include the matching Guardian velcro strap. The Bridge will come with a plug-in 5V adapter with a micro-USB connector. Reset, the button will be held for 10 seconds. The button will also be used for factory reset. Yet, or in exclusion mode if it is currently included. Press (3 presses in under 2 seconds) will put the bridge in Z-Wave inclusion mode if it has not been included The single button will on the back will be used to pair the Bridge with a valve controller or a Z-Wave hub.Ī single press will be used to pair the Bridge to a valve controller (like shaking the leak detector). Valve controller when hotspot is on) and on when paired to the hub.īridge is not included in a ZWave network The Z-Wave LED will be off when not paired to a Z-Wave hub, blinking (same pattern as WiFi light on The power and GuardianRF LEDs on the front of the Guardian Bridge will behave the same as the Guardian. The Guardian Bridge translates communication from GuardianRF to either RelayLinkTM or Z-Wave.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |